Before connecting ZKTeco device to the server, you need to switch it on, connect to your local network, and configure network settings parameters. To do this, open COMM. -> Cloud Server Setting in the device menu and set the following values:
- Server address is the server IP address, to which the device will be connected;
- Port - the default value is 8899;
- HTTPS - enabled.
After that, open the System settings and set the following value:
- Device Type Setting - Access Control Terminal.
Tip
In order to increase Access Control security, it is recommended to create a new user with the administrator privileges and use it to connect to TRASSIR ACS.
- TRASSIR ACS does not support some authentication modes (by palm, finger veins or QR code), available on ZKTeco terminals. You can see the list of all supported modes in the reader settings, after connecting the device.
- The card numbers, read out on ZKTeco terminals, can be used for authentication on Hikvision terminals, operating on Wiegand-26 interface,and vice versa.
- The fingerprints read on other manufacturers' devices are not supported on ZKTeco terminals. If you use other manufacturers' access control devices, each device must be uploaded with "own" fingerprints.
- ZKTeco devices do not check uploaded person photos.
