BAS-IP devices use their own data format for cards, which differs from the formats of devices from other manufacturers. Therefore, it is extremely important to configure the correct data format on all devices. Otherwise, it will not be possible to record cards and provide access to them.
Important
For all devices, specify a data format: Wiegand 26, Wiegand 34 or Wiegand 58. The format should correspond to the data format of the cards used for access.
For persons' IDs, use numbers of the cards corresponding to the selected data format:
- for Wiegand 26: 8-digit card number;
- for Wiegand 34: 10-digit card number;
- for Wiegand 58: 16-digit card number.
Tip
To configure parameters of a BAS-IP device with inbuilt BLE (Bluetooth Low Energy) module, use BAS-IP UKEY Config mobile app:
Setting procedure
-
Launch the app and connect the device you want to configure via Bluetooth.
-
Specify a data format for the output interface.
Click Security -> Output interface and select a data format: Wiegand 26, Wiegand 34 or Wiegand 58.
-
Configure a Mifare card reading template.
Click Advanced settings -> Mifare card reading template and select Reverse sequence.
-
After changing the settings, reboot the device.
